Be sure to choose the correct one.
Replacement LED driver power supply for any of the Santa Monica scrubbers or GEM lights. These power supplies can also be used to build DIY your own scrubber, using three-watt LEDs
HERE , and for a HOG the cases are
HERE and
HERE and the heat sinks are
HERE
12 month warranty.
The current type is a plug-in style. The previous version (until about 2020) was a soldered-style without a plug. The newer plug-style is easy to unplug for harvesting or replacement, but must be kept clean and dry. If you have the previous soldered-style (without a plug) and need to replace it, the new plug style will work fine; you will just need to solder the plug wire first. If you already have the plug style, then the replacement plug style will plug right in.
These power supplies are similar to a laptop power supply, where the AC power cord unplugs, and you can plug in a different cord for a different country. So they all operate on 240 and 120 volts without further changes, and have the little figure-8 plug (C7) which your computer laptop cable can plug right into. So you can use your laptop's power cable to plug into these adapters directly if needed. Has UL, Canadian UL, and CE safety certificate, and gives less than 600ma for long LED life.
Choose the number of LEDs you need to power:
1 or 2 LEDs:
DROP.2
DROP.6
DROP.6x
DROP1.4x (needs two supplies: one for 4 LEDs on the side walls, and one for 2 LEDs on the back wall).
HOG.5
HOG1
HOG1.3
3, 4, 5 or 6 LEDs:
DROP1.2
DROP1.2x
DROP1.4
DROP1.4x (needs two supplies: one for 4 LEDs on the side walls, and one for 2 LEDs on the back wall).
HOG1x
HOG2
HOG2x
HOG3
HOG3x (needs two supplies)
HOG3xx (needs two supplies)
SURF2
SURF2x
SURF4 (needs two supplies)
SURF4x (needs two supplies)
SURF8 (needs two supplies for each light; total of four supplies)
SURF8x (needs two supplies for each light; total of four supplies)
RAIN2
RAIN4 (needs two supplies)
SLIP.7
GEM5 (one supply powers a set of four GEM5 lights). This power supply is the same one for the RAIN and SLIP models (because RAINs and SLIPs also use GEM5 lights) and is also listed on the GEM5 page
HERE
SLIP.7 has one GEM5 light inside, and can be powered by a RAIN / GEM5 supply, or a 3,4,5,6 LED plug-style supply. The difference is that a RAIN / GEM5 supply has four outputs which can power four SLIP.7 units, whereas the 3,4,5,6 LED in series supply only has one output. Thus the higher cost of the RAIN / GEM5 supply.
