Replacement LED driver power supply for any of the Santa Monica scrubbers or GEM lights. These power supplies can also be used to build DIY your own scrubber, using three-watt LEDs HERE
and cases HERE
, and for a HOG the heat sinks are HERE
12 month warranty.
These power supplies are similar to a laptop power supply, where the AC power cord unplugs, and you can plug in a different one for a different country. So they operate on 240 and 120 volts without further changes, and have the little figure-8 plug which your computer laptop cable can plug right into. Has UL, Canadian UL, and CE safety certificate, and gives less than 600ma for long LED life. Choose the number of three-watt LEDs you need to power:
1 or 2 of the three-watt LEDs in series:
DROP1.4x in low power mode (2 LEDs on the back wall).
3, 4, 5 or 6 of the three-watt LEDs in series:
DROP1.4x in high power mode (4 LEDs on side wall)
HOG3x (needs two supplies)
HOG3xx (needs two supplies)
SURF4 (needs two supplies)
SURF4x (needs two supplies)
SURF8 (needs two supplies for each light; total of four supplies)
SURF8x (needs two supplies for each light; total of four supplies)
These power supplies are just for replacement, and not for DIY:
RAIN4 (needs two supplies)
GEM5 (one supply powers a set of four GEM5 lights). This power supply is the same one for the RAIN models (because RAINs also use GEM5 lights) and is also listed on the GEM5 page HERE
SLIP.7 has one GEM5 light inside, and can be powered by a RAIN / GEM5 supply, or a 3,4,5,6 LED in series supply. The difference is that a RAIN / GEM5 supply has four outputs which can power four SLIP.7 units, whereas the 3,4,5,6 LED in series supply only has one output. Thus the higher cost of the RAIN / GEM5 supply.